To start with, you will need to field strip your RIA 1911 pistol and remove both of the grip panels. Unload the pistol and remove all ammunition from the immediate area. Besides adding a finished look to the Hogue Monogrip Wraparound with Finger Grooves, it also prevents the plunger tube from flying off the pistol should it decide to do so. The top end of the left side grip panel is such so that it partially covers the Plunger Tube housing. The issue is with the safety lever itself it will not clear the grip at the top of the grip – on either side. Rock Island Armory Ambidextrous SafetyThe RAI series of 1911 pistols has a pin that holds the right side safety lever in place the recess is not needed to hold the safety in place. Fitting the grip around the frame can be a challenge and I’ll cover that a little bit later. Also, the Hogue Monogrip Wraparound with Finger Grooves may take some effort to get them secured, but that is not the first concern. For surgery work, you will need a good X-Acto knife of small and medium varieties and something to mark the areas to be relieved. Taking cues from the relieving of the VZ grip panels, I ordered another Hogue Monogrip Wraparound with Finger Grooves and a set of Hogue Stainless Steel Grip Mounting Screws.Ĭonfiguring the Hogue Monogrip Wraparound with Finger Grooves to the RIA 1911A1 FS Tactical does take some surgery. Obviously, I had to try and install the Hogue Monogrip Wraparound with Finger Grooves one more time (I am a bull-headed sort of fellow). With these grips, my hand is forced as high on the back strap as possible from the draw-stroke and the pistol feels like it has better balance – possibly due tot eh leverage the grip affords to the hand. The Hogue Monogrip Wraparound with Finger Grooves fills in the front of the grip below the trigger guard, the finger groove depth and spacing are perfect for my fingers, the girth of the pistol is increased slightly, felt recoil seems less, and I feel that I have a lot better control of the pistol as compared to not using them. Ever since I began using the Hogue Monogrip Wraparound with Finger Grooves on my 1911 carry pistols, I realized how attached to these grips I have become. Lately, I have been carrying the RIA 1911A1 FS tactical as my EDC that, of course, has an ambidextrous thumb safety and a set of Uncle Mike’s rubber grip panels. Instead, I ordered a pair of VZ grips that fit the RIA 1911A1 MS Tactical perfectly, as they are relieved in the proper ears to enable the thumb safety to operate as it should. Luckily, the Hogue 1911 Wraparound Grip with Finger Grooves is not expensive and no great amount of money was lost. Hogue Monogrip with Finger Grooves for 1911 Government PistolsI did attempt, at one point, to try and fit the Hogue Monogrip Wraparound with Finger Grooves to a RIA 1911A1 FS Tactical and failed miserably.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |